Swivel Chair Replacement Parts
Plycraft Lounge chair tilter placement is important. See General Installation.
For other installations, we recommend temporarily using the Trial mode method as described in General Installation to ensure proper placement. 9" x 12" x 3/4" trial mounting plywood boards are inexpensive and available. The mounting board is secured to the bottom of the chair using the original mounting holes. Longer fasteners (#906B) may now be necessary. Then, the mechanism is screwed to the mounting board with #6090S mounting screws. Always predrill a pilot hole first.
When satisfied with placement, measure or make a mark off to the side where the pivot pin should be located after permanent mounting. Remove any upholstery, temporary plywood and mark the location of the 4 Style #14 Tee-nut holes on the outside seat bottom. Use a 5/16" drill bit to drill the 1/4" Tee-nut holes starting from the outside bottom.
To install Tee-nuts, finger press Tee-nut from the inside of the chair seat until the large flange containing the gripper points touch wood. Then hammer until flush to the 3/8" thick plywood seat surface.
Using our Style# #901B serrated head flange bolts, place tilter in position, install and tighten flange bolts, replace any upholstery and slip on the leg base.